Home arrow Easy Installation
Installing your Original Nailer Shoe. PDF Print E-mail
Installation is quick and easy! You will need a hex wrench or allan wrench and about 1 minute.  Follow these easy steps:

Important: Before you begin...

Step 1:  Disconnect the nailer from the air compressor and air line.  You should always wear eye protection when working with air tools.
 Image Step 2:  Remove the hex head machine screws from the bottom of the nailer and set them aside temporarily .
ImageStep 3:  Remove the original base plate from the nailer.
Image Step 4:  Place the Original Nailer Shoe onto the nailer, carefully aligning the holes on the plate with the holes on the nailer base.
Image Step 5:  Replace the hex head machine screws  and tighten the Original Nailer Shoe onto the nailer.  Make sure the machine screws are drawn just below the surface of the base plate so as not to scratch the floor.
Image Step 6:  Your nailer is now ready for use!  Attach the nailer to the air line and begin nailing.
 
[ Back ]
Testimonials
"Great product, I wish I had it at the start of the project"
A Jordan, WI, United States
 
"I can't imagine installing another floor without my Nailer Shoe!"
R Nakoneshny Saskatchewan, Canada
 
"Great Shoes, picked it up today and very happy with it. I will surely be back!"
K Cong, Ontario, Canada
 
Just finished putting in my hardwood floor and the nailer shoe was invaluable, I think we only wasted three boards on miss hits (our fault not the product's) in over 600 square feet put in and we were novices!  Everything worked tremendously well couldn't be happier! I used it on a Ramsond nailer.  Awesome product...a must have if you are considering putting in hardwood, thanks"
D Rentmeister, Yellowknife, N.W.T.
 
Who's Online
We have 1 guest online
Polls

naxx media website design internet consulting and marketing Saskatoon